Sealey AK422 - Manual

INSTRUCTIONS FOR:
BATTERY TERMINAL
CRIMPING TOOL
Model No:
AK422
1. SAFETY INSTRUCTIONS
2. INTROdUCTION
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give
you years of trouble free performance.
IMPORTANT: READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.
USE THE TOOL CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE
AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
 WARNING! Ensure Health and Safety, local authority and general
workshop practice regulations are adhered to when using tools.
 dO NOT use tools if damaged.
 Wear approved eye protection. A full range of personal safety
equipment is available from your Sealey dealer.
 Wear suitable clothing to avoid snagging. Do not wear jewellery
and tie back long hair.
 Maintain tool in good and clean condition for best and safest
performance.

When not in use, clean and lubricate tool, and store in a safe,
dry, childproof location.
 IMPORTANT: This manual is provided as a guide only, refer
to the vehicle manufacturer’s service instructions, or a
proprietary manual, to establish the current procedure and
data.

WARNING! Failure to heed safety and warning instructions may
result in damage and/or personal injury and will invalidate the
warranty.

WARNING! The warnings, cautions and instructions
referred to in this manual cannot cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are factors
which cannot be built into this product, but must be
applied by the operator.
A quick and effective way of crimping battery terminals using either
a hammer or vice. Wide throat and spring controlled punch securely
holds terminal in place for added security. Compatable with battery
terminals with a cross sectional area of 6, 10, 16, 25, 35 and 50mm².
3. OPERATION
3.1. Select the appropriate sized terminal to fit the cable being
worked on. Strip off cable insulation to a length approximately
3mm longer than the length of the terminal barrel.
3.2. Insert stripped cable fully into battery terminal (or connector).
Lift ram of tool and place terminal on anvil so bottom of ram rests
on the middle of terminal barrel.
3.3. Strike ram with a hammer (or put tool in a vice and tighten) until
the line on the ram corresponds to the cable size used and is
even with the top of the tool.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK distributor, Sealey Group,
Kempson Way, Suffolk Business Park ,
Bury St. Edmunds, Suffolk,
IP32 7AR
©Jack Sealey Ltd Original Language Version AK422 Issue: 1 - 26/09/13
01284 757500
01284 703534 [email protected]
www.sealey.co.uk
W e b
email
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.