Magnum Energy MSH-M Series - Manual (Page 52)

©
2013 Magnum Energy, Inc. Page 43
Appendix A – Specifi cations
Model MSH3012M MSH4024M
Inverter Specifi cations
Input battery voltage range 9.0 to 17.0 VDC 18.0 to 34.0 VDC
Absolute maximum DC input 25 VDC 35 VDC
AC output voltage accuracy 120 VAC ±3% (≤ continuous power)
Output frequency and accuracy 60 Hz ± 0.05 Hz
Total Harmonic Distortion (THD) < 5%
Continuous power output (at 25°C) 3000 VA 4000 VA
Continuous AC output current 25 A 33 A
1 msec surge current (amps AC) 70 120
100 msec surge current (amps AC) 40 72
5 sec surge power (real watts) 3900 5800
30 sec surge power (real watts) 3800 5400
5 min surge power (real watts) 3200 4900
30 min surge power (real watts) 3000 4500
Maximum continuous input current 400 ADC 267 ADC
Inverter effi ciency (peak) 90.0% 93.7%
HBCO/HBCI (High Battery Cut Out/In) 16.8 VDC/16.5 VDC 33.6 VDC/33.0 VDC
LBCO/LBCI (Low Battery Cut Out/In) 9.0 VDC (adj)/12.5 VDC 18.0 VDC (adj)/25.0 VDC
Inverter stacking (series or parallel) No No
AC relay transfer time (minimum) <16 msec
Power consumption – searching <7 watts
Power consumption – inverting (no load) 30 watts 25 watts
Output waveform Pure Sine Wave
Charger Specifi cations
Continuous charger output at 25°C 125 ADC 110 ADC
Input current for continuous rated output 18 AAC 28 AAC
Maximum current during load support 224 ADC 160 ADC
Charger effi ciency 87%
AC input frequency range 50 to 70 Hz
AC input voltage range 60 to 140 VAC (120 VAC nominal)
Power factor > 0.95
General Features and Capabilities
Transfer relay capability 60 AAC maximum each input
Five-stage charging capability Bulk, Absorb, Float, Equalize (requires remote), and Battery Saver™
Battery temperature compensation Standard with available temp sensor connected (battery temp 0 - 50 °C)
Internal cooling 0 to 120 cfm variable speed drive using dual 92 mm brushless DC fan
Overcurrent protection Yes, with two overlapping circuits
Over-temperature protection Yes, on transformer, MOSFETS, and battery
Corrosion protection PCB’s conformal coated, powder coated chassis/top, and stainless steel fasteners
Safety listings ETL listed to UL/cUL 458, CSA C22.2 No. 107.1-01
Warranty 3 years parts and labor
Branch-rated output circuit breakers No
Environmental Specifi cations
Operating temperature -20°C to +60°C (-4°F to 140°F)
Non-operating temperature -40°C to +70°C (-40°F to 158°F)
Operating humidity 0 to 95% RH non-condensing
Physical Specifi cations
Unit dimensions (length x width x height) 13.75” x 12.65” x 8.0” (34.9 cm x 32.1 cm x 20.3 cm)
Shipping dimensions (l x w x h) 19” x 17” x 13” (48.3 cm x 43.2 cm x 33 cm)
Mounting Shelf or wall (vents not allowed to face downward unless ME-CB or MPX-CB is installed)
Weight Unit: 55 lb (24.9 kg) / Shipping: 63 lb (28.6 kg)
Max operating altitude 15,000 ft (4570 m)
Specifi cations @ 25°C - Subject to change without notice.
Appendix A – Specifi cations and Optional Equipment
A-1 Inverter/Charger Specifi cations