LinPlug CrX4 - Manual (Page 32)

Delay
The Delay effect can be used to create echoes and other related effects.
The Time slider is used for
setting the delay time (in
milliseconds). This can range
from 1 ms to 680 ms and is
displayed right of the slider.
The time display also
functions as a Sync popup
menu which can be used to
sync the delay time with the current host (DAW) tempo (see Appendix A for
the range of possible sync settings).
The Feedback slider allows you to adjust the number of times the signal
repeats or echoes.
Also included in the Delay section is a variable low pass/high pass 6dB/Oct
filter which is adjusted with the Filter slider. Negative values means a low
pass filter is applied, while positive values mean a high pass filter is
applied. The higher the absolute value of the Filter slider, the more the filter
will modify the delayed signal.
The Mod Rate sets the rate (in Hz) at which modulation takes place. Again
the rate display also functions as a Sync popup menu when you click it.
The Mod Depth slider is used to set the depth to which the delayed signal
is modulated, while the Rate slider determines the modulation speed. For
example, if you set a delay time of 100ms and a depth of 50%, the amount
of modulation is 50% of 100ms (50 ms). In this case you'll get a delay time
that varies from 100 - 50ms (50ms) up to 100 + 50ms (150ms).
When modulation is applied a stereo effect is created because both
channels are modulated in opposite directions.
CrX4 User Manual 32