SMA SI-TB-BOX-10 - Manual (Page 53)

SMA America, LLC 9 Mounting and Disassembling the Contact Hazard Protection Cover
Installation Manual SI_TDBOX-IA-eng-IUS122211 53
9.2 Mounting the Contact Hazard Protection Cover
1. Ensure that the Smartformer is disconnected from the power supply (see Section 10).
2. Position the left side of the contact hazard
protection cover against the right-hand side of the
Smartformer and, with the cover at an angle to the
left, push back the contact hazard protection cover
in a straight movement. Do not touch any
components or terminals in doing so.
3. Lower the right-hand side of the contact hazard protection cover towards the back.
☑ Contact hazard protection cover is in place in
the Smartformer.