SMA SB 3000TL-US Installation - Manual (Page 30)

5 Mounting SMA America, LLC
30 SB3-5TLUS22-IA-en-16 Installation Manual
5.3 Mounting the Inverter and DC Disconnect
2. Hang the inverter in the wall mounting bracket.
3. Ensure that the inverter is securely in place.
4. Remove the lower lid.
5. Carefully pierce the rubber grommet on the upper side of the DC Disconnect using a
screwdriver.
1.
Risk of injury when lifting the inverter, or if it is dropped
The inverter is heavy (see Section 13 "Technical Data", page 82). Risk of injury exists due to
incorrect lifting and due to the inverter falling during transport or when hanging in the wall
mounting bracket.
• Lift and transport the inverter horizontally in the mounting position. Use the recessed grips
on the sides for this.