Emerson FM-3 - Manual (Page 88)

74
FM-3 Programming Module Reference Manual
Drag and Drop Method
First, position your pointer over the source on the left that you wish to assign to the destination
on the right. Press the left mouse button while over the source, and hold the button down.
While holding the left button down, drag the source over until your pointer is positioned over
the desired destination and release the left mouse button.
Destinations can also be dragged over to sources.
Assign Button Method
Click on both the source and destination you wish to assign to each other. Once both are
highlighted, the Assign button in the lower left corner of the view will become enabled. Click
on the Assign button to complete the assignment. Figure 46 shows the source and destination
highlighted, and the Assign button has just been clicked.
Once an assignment has been made, you will see the “Assigned to..” and the “Set From”
columns be filled in for the specific sources and destinations. This indicates what
destination(s) an individual source has been assigned to, and what source(s) an individual
destination is assigned to.
Any source can be assigned to up to ten different destinations maximum. Any destination can
have as many sources as desired assigned to it.
Deleting An Assignment
Delete Button Method
Click on both the source and destination your wish to delete. Once both are highlighted, the
Delete button will become available. Click on the Delete button to remove the assignment.
Right Click Method
Position the pointer over the specific assignment you with to delete and click the right mouse
button. A selection box will appear. From this selection box, choose Delete.
After either of these procedures, the assignment will disappear.