Emerson FM-3 - Manual (Page 48)

34
FM-3 Programming Module Reference Manual
Switching Frequency Group
This parameter defines the switching frequency of the electronic amplifier. For EN drives, the
switching frequency must be 20 kHz and cannot be changed. For MDS, the switching
frequency can be modified to change system performance. Available selections are 5 kHz,
and 10 kHz. For more information on this setting refer to the MDS Reference Manual, P/N
400525-01.
Status Online Tab (Online Only)
The Status Online tab (see Figure 29) is visible when online and consists of the Motor
Position group, Motor Velocity group, Control Loop group, Master Feedback group, and the
Torque group.
Figure 29: Setup View - Online Status Tab