Emerson FM-3 - Manual (Page 239)

225
Diagnostics and Troubleshooting
Diagnostic Display
The diagnostic segment display on the front of the drive shows drive status, FM-3 module
status, and fault codes. When a fault condition occurs, the drive will display the fault code,
overriding the status code. The alphanumeric display on the FM-3 module provides additional
fault information.
The decimal point is “On” when the drive is enabled, and the stop input is not active. This
indicates that the drive is ready to run and any motion command will cause motion. Motion
commands will not cause motion unless you are Ready (R) and the decimal point is “On”.
Display Indication Status Description FM-3 Keypad Display
Ready
The FM-3 and drive system is functioning
normally and is ready to execute a motion
command. Drive Type Address
Motor Type
Menu Groups
Brake Engaged (Output "Off")
Motor brake is mechanically engaged. This
character will only appear if the Brake output
function is assigned to an output line. See
Brake Operation section for detailed
description of Brake Output function.
Drive Type Address
Motor Type
Menu Groups
Disabled Power Stage is disabled.
Drive Type Address
Motor Type
Menu Groups
RMS Foldback Motor torque is limited to 80 percent.
Drive Type Address
Motor Type
Menu Groups
Stall Foldback
Drive output current is limited to 80 percent of
drive stall current.
Drive Type Address
Motor Type
Menu Groups
Ready to Run Drive enabled. No stop input.
Drive Type Address
Motor Type
Menu Groups
Homing Home is executing.
Drive Type Address
Motor Type
Menu Groups
FM-3 Programming Module Reference Manual