Eagle Electronics SeaChamp 2000 - Manual (Page 89)

81
Main Menu with Sonar Setup command selected (left). Sonar
Simulator menu with simulator turned on (right).
NOTE
With Simulate Position checked, the simulator will also
automatically run the GPS simulator (if GPS data was recorded
with the sonar log).
2. To use the default sonar chart log stored in the unit, press ENT | EXIT .
The recorded chart begins scrolling across the screen, just as if you
were on the water.
3. Turn off the Sonar Simulator by pressing MENU | MENU |
↓ to
S ONAR
S
ETUP
| ENT |
↓ to
S
ONAR
S
IMULATOR
| ENT | EXIT .
Sonar Page playing a recorded sonar chart in Sonar Simulator mode.
Tip:
The Sonar Simulator can use sonar charts recorded (logged) on a
MMC card. (To see how, read the entry in this section on Log Sonar
Chart Data.) To play a sonar chart, make sure the MMC containing
the chart is installed, then:
1. Press MENU | MENU |
↓ to
S ONAR S ETUP
| ENT |
↓ to
S ONAR S IMULATOR
| ENT .
2. Press
↓ to
C HART U SED
| ENT .
3. Press
↓ or ↑ to select chart name|
ENT |
↑ to
S ONAR S IMULATOR
O
N
| ENT | EXIT .
"Play"
symbol
flashing
Title bar
with chart
file name