Eagle Electronics SeaChamp 2000 - Manual (Page 124)

116
The unit will display a completion message when the data transfer is
finished. To return to the Page view, repeatedly press
EXIT .
From left to right, these figures show the sequence for naming and
saving a GPS Data File from the unit's memory to a MMC.
4. Loading to unit memory: There may be more than one GPS Data
File (*.USR) on the card. To select a file, press ENT to activate the MMC
Card selection box, use ↓ or ↑ to highlight the file, then press ENT . Next,
press ↓ to LOAD | ENT. The unit will display a completion message when
the data transfer is finished. To return to the Page view, press
EXIT | EXIT | EXIT .
These figures show the menu sequence for loading a GPS
Data File from an MMC into the unit's memory.
Cancel Navigation
You can turn off any of the navigation commands after you reach your
destination or at any other time by using the Cancel Navigation
command. Press
MENU | MENU |
↓ to
C
ANCEL
N
AVIGATION
| ENT | ← to Y
ES
| ENT .
Figure 2. Figure 1.