Eagle Electronics SeaChamp 2000 - Manual (Page 136)

128
Set a Waypoint by Projecting a Position
This feature sets a waypoint at a point located a specific distance and
bearing from a reference position. The reference position could be a
waypoint map feature, an item from your waypoint list or a location
from the Points of Interest list.
1. Press WPT |
→ to
S
UBCATEGORY
column|
↓ to
N
EW
| ENT .
2. Press
↓ to
P ROJECTED P OSITION
| ENT |
→ to
C REATE
| ENT .
3. Press
→ to
C
HOOSE
R
EFERENCE
| ENT . Use
↑ and ↓ to select a waypoint,
map feature or Point of Interest. When the point has been selected,
press
ENT and the point's position appears as the reference position.
4. Press
↓ to
D ISTANCE
| ENT . Press
↑ or ↓ to change the first character,
then press
→ to the next character and repeat until the distance is
correct. Press ENT .
5. Press
↓ to
B EARING
| ENT . Press
↑ or ↓ to change the first character,
then press
→ to the next character and repeat until the bearing is
correct. Press ENT .
6. Press
↑ to
P
ROJECT
| ENT . The Edit Waypoint menu appears. You can
simply save the new projected waypoint by pressing EXIT | EXIT or you
can edit the waypoint. (Press EXIT | ENT if you want to immediately
begin navigating to the new waypoint.)