Eagle Electronics SeaChamp 2000 - Manual (Page 44)

36
MMC or SD Memory Card Installation
Your unit uses MultiMedia Cards to store information, such as sonar
logs, custom maps, waypoints, trails and other data. The unit can also
use Secure Digital Cards (SD card) to store data. The unit can use up to
two cards; a MMC and a SD card can be used at the same time.
NOTE
Throughout this manual, we will use the term MMC, but just
remember your unit can use an MMC or SD card to store data.
Both of these solid-state flash memory devices are about the size of a
postage stamp. A SD card is slightly thicker than a MMC. MMCs are
available in storage capacities of 8 MB, 16 MB, 32 MB, 64 MB, 128 MB
and higher. SD cards are available in capacities of 8 MB, 16 MB, 32
MB, 64 MB, 128 MB, 256 MB and 1 GB.
Additional MMC cards are available from LEI Extras; see ordering
information inside the back cover of this manual. MMCs and SD cards
are also available at many camera and consumer electronics stores.
The MMC drawer is located on the front of the case. To install an
MMC, twist the drawer retainer counter-clockwise and pull.
The drawer will come out of the unit. Place the MMC in the drawer face
down (see following figures.)
Memory card drawer on the FishStrike 2000 and SeaChamp 2000.
Slide the drawer back into the unit and twist the retainer clockwise.
The MMC is now ready for use.
Insert cards face down
Drawer
retainer