Eagle Electronics SeaChamp 2000 - Manual (Page 121)

113
4. Press
↓ to
N
AVIGATE
| ENT . The unit begins showing navigation
information along the trail.
NOTE:
If you are already located at or near the beginning of your trail, the
arrival alarm will go off as soon as you hit
ENT . Just press EXIT to
clear the alarm and proceed.
5. Now, begin moving and let your GPS guide you.
6. When you reach your destination, be sure to cancel navigation.
Press
MENU | MENU | ↓ to C
ANCEL
N
AVIGATION
| ENT . The unit asks if you're
sure, press ← | ENT .
Navigate a trail menu sequence: Fig. 1, My Trails command. Fig. 2,
Trails Menu. Fig. 3, Edit Trail Menu. Fig. 4, Edit Route Menu with
Navigate command highlighted for Trail 6. A trail is always converted
to a route when you navigate the trail.
On the Map Page, a course line represents the trail you are navigating.
The bearing arrow on the compass rose points to the next waypoint on
the trail.
Figure 3. Figure 4.
Figure 1. Figure 2.