HEIDENHAIN iTNC 530 (340 49x-02) Pilot User Manual
Page 74
74
D
e
fining Machining O
p
erations
Additional parameters on the pocket parameters detail form:
8
Infeed for finishing:
Infeed for finishing on the side. If nothing is
entered, finishing is performed in one infeed.
8
F rate for finishing:
Feed rate for finishing [mm/min], FU [mm/rev]
or FZ [mm/tooth]
8
Stepping angle:
Angle by which the entire slot is rotated further.
8
Number of repetitions:
Number of machining operations on a pitch
circle.
8
Slot position:
Position of the slot referenced to the programmed
position.
Globally effective parameters on the global data detail form:
8
Set-up clearance
8
2nd set-up clearance
8
Feed rate for traversing between machining positions
8
Climb milling, or
8
Up-cut milling
8
Plunge in a helical motion, or
8
Plunge in a reciprocating motion, or
8
Plunge vertically