HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 147)

147
G
raphically test and run
a
UNIT
pro
g
ra
m
The Execute UNIT program
A UNIT program can be run in the Execute submode in the following
manners:
„ Run the UNIT program unit by unit
„ Run the entire UNIT program
„ Run individual, active units
Procedure
8 Select the smarT.NC operating mode
8 Select the Execute submode
8 Press the RUN SINGLE UNIT soft key, or
8 Press the RUN ALL UNITS soft key, or
8 Press the RUN ACTIVE UNIT soft key
UNIT programs (*.HU) can be run in the smarT.NC operating
mode, or in the usual Program Run, Single Block or Program
Run, Full Sequence operating modes.
Please note the instructions on running programs in the
machine manual and the user’s manual.