HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 32)

32
D
e
fining Machining O
p
erations
Global data valid everywhere ( 1 )
8 Set-up clearance: Distance between tool tip and workpiece surface
for automated approach of the cycle start position in the tool axis.
8 2nd setup clearance: Position to which smarT.NC positions the tool
at the end of a machining step. The next machining position is
approached at this height in the machining plane.
8 F positioning: Feed rate at which smarT.NC traverses the tool within
a cycle.
8 F retraction: Feed rate with at smarT.NC retracts the tool.
Global data for positioning behavior ( 2 )
8 Positioning behavior: Retraction in the tool axis at the end of the
machining step: Return to the 2nd set-up clearance or to the position
at the beginning of the working unit.
1 1
1 2