HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 67)

67
D
e
fining Machining O
p
erations
Additional parameters on the pocket parameters detail form:
8 Infeed for finishing: Infeed for finishing on the side. If nothing is
entered, finishing is performed in one infeed.
8 F rate for finishing: Feed rate for finishing [mm/min], FU [mm/rev]
or FZ [mm/tooth]
8 Angle of rotation: Angle by which the entire pocket is rotated.
8 Pocket position: Position of the pocket referenced to the
programmed position.
Globally effective parameters on the global data detail form:
8 Set-up clearance
8 2nd set-up clearance
8 Overlap factor
8 Feed rate for traversing between machining positions
8 Climb milling, or
8 Up-cut milling
8 Plunge in a helical motion, or
8 Plunge in a reciprocating motion, or
8 Plunge vertically