HEIDENHAIN iTNC 530 (340 49x-02) Pilot User Manual
Page 18
18
Fu
nd
ame
n
ta
ls
Editing contours
1
1
2
1
3
1
4
1
4.1
1
4.2
1
4.3
1
5
1
6
1
Header: Operating mode text, error messages
2
Active background mode of operation
3
Tree view in which the contour elements are shown in a
structured format
4
Form window with the various input parameters. In FK
programming there can be up to four forms.
4.1: Overview form
Contains the input possibilities used most often
4.2: Detail form 1
Contains input possibilities for auxiliary points (FL/FLT)
and for circle data (FC/FCT)
4.3: Detail form 2
Contains input possibilities for auxiliary points (FL/FLT)
and for auxiliary points (FC/FCT)
4.4: Detail form 3
Only available for FC/FCT, contains input possibilities
for relative references
5
Support graphics window, in which the input parameter
currently active is displayed
6
Graphics window, in which the programmed contours
are show immediately after being saved in the form