HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 60)

60
D
e
fining Machining O
p
erations
Additional parameters on the drilling parameters detail form:
8 Chip breaking depth: Depth at which the TNC is to carry out chip
breaking during drilling.
8 Upper adv. stop dist.: Set-up clearance for when the TNC returns
the tool to the current plunging depth after chip breaking.
8 Depth at front: Depth for sinking at front.
8 Offset at front: Distance by which the TNC moves the tool center
from the hole center
Globally effective parameters on the global data detail form:
8 Set-up clearance
8 2nd set-up clearance
8 Positioning feed rate
8 Retraction value for chip breaking
8 Feed rate for traversing between machining positions
8 Climb milling, or
8 Up-cut milling