Opening a dxf file – HEIDENHAIN iTNC 530 (340 49x-02) Pilot User Manual
Page 134
134
Gener
a
ti
ng C
ont
ou
r Pr
og
rams
from DXF Data (Software
Opening a DXF file
The DXF converter can be started two different ways:
From the file management if you want to extract separate contours
consecutively.
From the form during the machining definition of units 125 (contour
train) and 122 (contour pocket) if you are supposed to enter the names
of the contours to be edited.
Starting the DXF converter through the file management
8
Select the smarT.NC operating mode
8
Call the file manager
8
In order to see the soft-key menu for selecting the file type
to be displayed, press the SELECT TYPE soft key.
8
To show all DXF files, press the SHOW DXF soft key.
8
Select the desired DXF file, and load it with the ENT key.
smarT.NC starts the DXF converter and shows the contents
of the DXF file on the screen. The TNC shows the layers in
the left window, and the drawing in the right.