HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 46)

46
D
e
fining Machining O
p
erations
Unit 202 Boring
Parameters on the overview form:
8 T: Tool number or name (switchable via soft key)
8 S : Spindle speed [rpm] or cutting speed [m/min or ipm]
8 F : Drilling feed rate [mm/min] or FU [mm/rev]
8 Depth: Boring depth
8 Disengaging direction: Direction in which smarT.NC moves the tool
away from the counterbore floor.
8 Machining positions (see “Defining Machining Positions” on page 111.)
Additional parameters on the tool detail form:
8 DL: Delta length for tool T.
8 M function: Any miscellaneous function M.
8 Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3.
8 Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent).