HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 25)

25
Fu
nd
ame
n
ta
ls
Copying units
You can copy individual machining units very easily with the familiar
Windows shortcut keys:
„ Ctrl+C to copy the unit
„ Ctrl+X to cut the unit out
„ Ctrl+V to insert the unit behind the active one
If you want to copy two or more units at the same time, proceed as
follows:
8 Switch to the top level of the soft-key row
8 Use the cursor keys or the mouse to select the first unit to
be copied
8 Activate the marking function
8 Use the cursor keys or the MARK NEXT BLOCK soft key to
select all units to be copied
8 Copy the marked block to the clipboard (also works with
Ctrl+C)
8 Use the cursor keys or soft key to select the unit just before
the desired insertion point for the copied block
8 Insert the block from the clipboard (also works with Ctrl+V)