HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 40)

40
D
e
fining Machining O
p
erations
Unit 240 Centering
Parameters on the overview form:
8 T: Tool number or name (switchable via soft key)
8 S : Spindle speed [rpm] or cutting speed [m/min or ipm]
8 F : Centering feed rate [mm/min] or FU [mm/rev]
8 Select Depth/Diameter: Select whether centering is based on the
depth or diameter.
8 Diameter: Centering diameter. Input of T-ANGLE from TOOL.T
required.
8 Depth: Centering depth.
8 Machining positions (see “Defining Machining Positions” on page 111.)
Additional parameters on the tool detail form:
8 DL: Delta length for tool T.
8 M function: Any miscellaneous function M.
8 Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3.
8 Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent).