HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 122)

122
Defining
Mach
ining
Posit
io
ns
Full circle
8 Center in 1st axis: Coordinate of the circle center point
( 1 ) in the major axis of the working plane.
8 Center in 2nd axis: Coordinate of the circle center point
( 2 ) in the minor axis of the working plane.
8 Diameter: Circle diameter.
8 Starting angle: Polar angle of the first machining position.
Reference axis: Major axis of the active machining plane
(e.g. X for tool axis Z). You can enter a positive or negative
value.
8 Number of repetitions: Total number of machining
positions on the circle.
smarT.NC always calculates the angle increment between
two machining positions by dividing 360° by the number of
machining operations.