HEIDENHAIN iTNC 530 (340 49x-02) Pilot - Manual (Page 72)

72
D
e
fining Machining O
p
erations
Unit 254 Circular Slot
Parameters on the overview form:
8 Machining operation: Select via soft key roughing and finishing, or
only roughing, or only finishing.
8 T: Tool number or name (switchable via soft key)
8 S : Spindle speed [rpm] or cutting speed [m/min or ipm]
8 F : Feed rate for plunging [mm/min], FU [mm/rev] or FZ [mm/tooth]
8 F : Feed rate for plunging [mm/min] or FU [mm/rev] or FZ [mm/tooth]
8 Center in 1st axis: Center of pitch circle in reference axis.
8 Center in 2nd axis: Center of pitch circle in auxiliary axis.
8 Pitch circle diameter
8 Starting angle: Polar angle of the starting point.
8 Angular length
8 Slot width
8 Depth: Final depth of the slot.
8 Plunging depth: Infeed per cut.
8 Allowance for side: Finishing allowance for the side.
8 Allowance in depth: Finishing allowance for the depth.
8 Machining positions (see “Defining Machining Positions” on page 111.)