HEIDENHAIN ND 1400 - Manual (Page 45)

31
4
Quick Start
Print a report
To print a report of the current position (Display), the feature list (Report) or tolerances (Tol Report):
1 Verify that the QC-330 is attached to a USB printer as described in Chapter 9: Communication.
2 Verify that the report content and printer formatting are specified correctly in the Print setup screen
described in Chapter 9: Communication and Chapter 10: Setup.
3 Press the Print key while displaying the Current Position in the DRO screen.
More information regarding reports of feature measurement data and QC-330 system settings are contained
in Chapter 9: Communication and Chapter 10: Setup.
Stop program recording
To end a recording session, touch the Program tab to display the programming tools, and then touch the
Stop icon to stop recording the program. The program title will be shown on the left side of the screen.
The program is now saved and can be edited or run on new parts. Touch the Measure tab to return to the
measure mode of operation and display the DRO.
Running the program
To run a program, touch the Program tab to display the program
screen, select the desired program and then touch the Run (play) icon
to run the selected program.
Quick Start Demonstration