HEIDENHAIN ND 1400 - Manual (Page 101)

87
8
Programming
Then measure the largest hole in
the 3D demo part. Details of per-
forming circle measurements are
described in Chapter 6: Measur-
ing.
Apply a tolerance
Tolerance operations are described in Chapter 7: Tolerancing. In this example, a position tolerance is ap-
plied to the hole feature measured in the last step.
Touch the Tol button to display the Tolerance screen, apply the position tolerance and touch the DRO but-
ton to return to the DRO screen.
Report results
Measurement results can be printed over the USB port or transmitted to a computer over the RS-232 se-
rial port. Parameters governing reports and data transmissions are configured in the Print setup screen
described in Chapter 9: Communication, and in Chapter 10: Setup.
Reporting is included in a program by simply pressing the Print key while in recording a
program.
Creating a Program
Touch the Tol button... apply the tolerance and touch the
DRO button...
to return to the DRO screen
Measurement data are displayed