HEIDENHAIN ND 1400 - Manual (Page 44)

30 QC-300 Series User’s Guide
Measure a feature
In this example, the largest hole in the 3D demo part will be measured. Feature measurements are de-
scribed in Chapter 6: Measuring.
Apply tolerances to a feature measurement
In this example, a true position tolerance will be applied to the circle measurement. More information
regarding tolerances is contained in Chapter 7: Tolerancing.
To apply a true position tolerance:
With the circle feature highlighted, touch the Tol screen button, touch the position tolerance icon, select
true position and enter nominal, limit or tolerance values. Error and Deviation values are generated as soon
as the Nominal and Tol Dia values are entered.
Pass/fail results are indicated by green and red colors in the tolerance screen and in the feature list. Pass is
indicated by green, fail is indicated by red in the tolerance screen. Any tolerance failure will be indicated
by a red mark next to the feature in the feature list. A green mark will be displayed in the feature list when
all tolerance tests pass.
Measurement data are displayed