HEIDENHAIN ND 1400 - Manual (Page 22)

QC-300 Series User’s Guide
Connecting the touch probe input
The fixed or manually indexed touch probe is connected to the
Renishaw ® connector on the rear of the QC-330.
1 Verify that the QC-330 is off.
2 Connect the touch probe to the Renishaw connector on the
rear panel.
Connecting a printer
The QC-330 supports certain USB printers. Printer models
should be specified by Metronics when the QC-330 is ordered,
or approved by Metronics later.
1 Verify that the QC-330 and printer power are off. Connect
the USB printer to the USB Type A port on the side of the enclo-
sure.
2 Make sure the USB cable plug is fully inserted.
Touch probe
connector
USB printer
port