Grass Valley DVCPRO Board Upgrade - Manual (Page 22)

DVCPRO Board Installation
22 DVCPRO Upgrade Installation
Removing the Board Hold-down Brackets
There are two hold-down brackets located in the circuit board area of the chassis
that must be removed in order to install other boards.
To remove the board hold-down brackets:
1. Use the Torx tool with the T10 tip to remove the exterior screw ( Êin
Figure 3) that secures the rear board hold-down bracket.
2. Lift the bracket ( Ë in Figure 3) up and out of the chassis and set it aside.
3. Use the Torx tool with the T10 tip to remove the interior screw ( Ì in
Figure 3) that secures the front board hold-down bracket.
4. Lift the bracket ( Í in Figure 3) up and out of the chassis and set it aside.
NOTE: Now would be a good time to do the memory upgrades mentioned in
“Master and Slave EDR Memory Requirements” on page 13.