Grass Valley K2 Summit Client Service Manual May.14 2010 - Manual (Page 96)

96 K2 Summit Production Client Service Manual 09 April 2010
Chapter 5 Removing and replacing FRUs
Power supply module removal
Access the power supply module from the rear panel. Remove as illustrated.
Codec module removal
Access the codec module from the rear panel. Remove as illustrated.
CAUTION: Improper removal can damage components on the board.
Make sure you slide the board straight out. Do not allow the back end
of the board to bang up against the lid after it is no longer secured by
the card guides.
After installing the replacement codec module, install the current version of K2
software. An over-install is all that is required. You do not need to first un-install the
software. This ensures that the board is flashed with the proper version to be
compatible with K2 software.
Slide out 3
Disconnect
power cord 1
Disengage lever 2
Slide out 2
Loosen thumbscrews 1
!