Grass Valley K2 Summit Client Service Manual May.14 2010 - Manual (Page 94)

94 K2 Summit Production Client Service Manual 09 April 2010
Chapter 5 Removing and replacing FRUs
External Parts Removal
This section provides the following procedures:
• “Front bezel assembly removal” on page 94
• “CompactFlash boot media removal” on page 95
• “Disk module removal” on page 95
• “Power supply module removal” on page 96
• “Codec module removal” on page 96
• “Codec option card removal” on page 97
• “Carrier module removal” on page 98
• “Fibre Channel board (optional) removal” on page 99
All the parts in this category can be removed and replaced without opening the K2
Summit Client cabinet.
Front bezel assembly removal
You can remove the bezel assembly while the K2 Summit Client is operating. If you
do so, make sure you replace it within three minutes to ensure that the correct
operating temperature is maintained.
Slide out 2
Loosen thumbscrews 1