Grass Valley K2 Summit Client Service Manual May.14 2010 - Manual (Page 73)

09 April 2010 K2 Summit Production Client Service Manual 73
Installing the Fibre Channel card driver
• If the file is not present, procure the file from f tp://ftp.grassvalley.com/pub/K2/
Microcode_and _Drivers/LSI_SCSIPORT. The filename is
LSI_SCSIPORT_1.21.25.00.zip. Then continue with this procedure
2. After restoring the image and restarting the K2 Summit Client, a Found New
Hardware wizard opens for the Fibre Channel controller. Install the driver on the
first FC port as follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .
c. Select SCSI and Raid Controllers and Have Disk .
d. Browse to C:\Windows and find LSI_SCSIPORT_1.21.25.00. Click Open and
OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
3. If the K2 Summit Client has a dual port Fibre Channel card, on the Found New
Hardware wizard, install the driver on the second FC port as follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .
c. Select Have Disk .
d. Browse to C:\Windows and find LSI_SCSIPORT_1.21.25.00. Click Open and
OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
4. On the Found New Hardware wizard, install the first LSI Pseudo Device as
follows:
a. Select Install from a list or specific location . Click Next .
b. Select Don’t search. I will choose the driver to install . Click Next .
c. Select Have Disk .
d. Browse to C:\Windows and find LSI_SCSIPORT_1.21.25.00. Click Open and
OK .
e. Start the driver install by selecting Next .
f. On the Hardware Installation page, click Continue Anyway .
g. Click Finish .
5. If the K2 Summit Client has a dual port Fibre Channel card, on the Found New
Hardware wizard, install the driver on the second LSI Pseudo Device port as
follows: