Grass Valley 8995DNC v.1.3.0 - Manual (Page 99)

8995UPC/DNC/UDX — Instruction Manual 99
Specifications
Specifications
Table 9. 8995 Module Specifications
Parameter Value
Serial Digital Input
Number and type of input 1 non-isolated terminating BNC
Input impedance 75 ohm
Input return loss > 15 dB from 5 MHz to 1.5 GHz
Input DC tolerance ± 0.25 V maximum
Serial mode hum voltage 1 V p-p to 60 Hz maximum
Auto equalization • 325 meters of Belden 1694A or 270 Mb/s
• 125 meters of Belden 1694A for 1.5 Gb/s
Reclocking Yes
Input signal type • 480i-(SD 59.94)
• 720p-(59.94
• 1080i-(59.94)
• 576I-(SD 50)
• 720p-(50)
• 1080i-(50)
• 1080p-(23.98)
Input auto sensing Yes
AFD (Active Format Description) reporting SMPTE 2016-1:2009, 2016-3:2009
Reference Signal Input (8900GEN-SM Genlock Submodule Installed)
Signal Type
Analog color black 525i/59.9(NTSC); 625i/50(PAL-B); SMPTE318M
(NTSC with 10 field AES ID)
Tri-level sync 720p59.94; 1080i59.94, 720p50, 1080i50, 1080p23.98
4 V composite sync Not supported
Active video Not supported due to effects on timing
Reference signal level 300 mV p-p +/- 6 dB
Reference signal to noise ratio (S/N) > 46 dB S/N
Serial Digital Outputs
Connector type Coax BNC, optional fiber optic SFP
Number of outputs 4
Output impedance 75 ohm
Return loss > 15 dB 5 MHz-270 MHz
> 15 dB typical 270 MHz -1.5 GHz
Output signal level SDI 800 mV p-p, +/- 10%
Rise/fall time (20-80%) 140 ps for HD
500 ps for SD
Output jitter
(FS mode, in low jitter mode) < 0.2 UI > 100KHz for HD
< 1.0 UI 10 Hz-100KHz for HD
< 0.2 UI 10 Hz and up for SD