Grass Valley 8995DNC v.1.3.0 - Manual (Page 54)

54 8995UPC/DNC/UDX — Instruction Manual
Configuration
Video Input Web Page
Use
this
link
Use the Video Input web page ( Figure 31 ) to select and monitor the video
input source to the module with the following:
Video Input Selection
This section provides the following for the video input signal:
• Select Input Video – select the input source from the rear module as either
Coax , Fiber RX 1 , or Fiber RX 2 .
Note Fiber optic inputs require the presence of a fiber optic submodule. See Fiber
Optic Video Inputs on page 22 .
• Signal Name – the signal name defined on the I/O Config web page by
the user or the default names will appear in each field.
• Signal State – this field reports the status of the input video signal as
Present , Not Present , or Not Supported (no fiber submodule installed).
Figure 31. Video In Web Page