Grass Valley 8995DNC v.1.3.0 - Manual (Page 78)

78 8995UPC/DNC/UDX — Instruction Manual
Configuration
Video Out Web Page
Use
this
link
Use the Video Out web page ( Figure 48 ) to enable or disable the SFP Fiber
Optic submodule outputs when present and enable or disable audio
re-embedding.
Note Fiber optic outputs will be present when either a Dual Transmitter option is
installed (TX1 and TX2) or a transceiver (TX2) is installed. Refer to
Table 1 on
page 19 for the correct submodule to use with your software version.
Output Enables
This section allows enabling of the following for the video output signal:
• Fiber TX1 – check the Enabled checkbox to enable the output of the Dual
Transmitter submodule installed.
• Fiber TX2 – check the Enabled checkbox to enable the output from the Dual
Transmitter or a Transceiver submodule.
• Audio Re-Embedding – checking this checkbox enables re-embedding of
the audio on the output signal. For no embedded audio on the output,
leave this unchecked.
Figure 48. Fiber Out Web Page