Ation, Status web page – Grass Valley 8995DNC v.1.3.0 User Manual
Page 43
8995UPC/DNC/UDX — Instruction Manual
43
Configuration
Status Web Page
Use
this
link
The Status web page (
shows an example of the
8995UDX + GEN) reports the input signal status of each of the video and
the reference inputs and outputs in both graphical and textual formats. It
also provides status reporting for the optional Genlock and Fiber Optic
submodules. Color coding of the display and the Status LED indicates the
signal status. Refer to
for a complete expla-
nation of the color coding.
Module Physical Structure
Status is reported for each of the following video or reference signals:
•
Video In – indicates the status of the video input to the module from the
coax BNC, or one of two possible fiber optic inputs (depending on the
type of fiber optic connector installed).
•
Video Out – not monitored in this application.
•
Genlock Ref In – indicates the status of the external genlock reference
signal at BNCs J1 and J3 (Genlock Loop).
•
Local Ref – indicates the status of the internally generated genlock ref-
erence signal from the 8900GEN submodule to the front module.
•
Frame Bus – indicates the status of the communication bus to the
8900NET module.
•
Ref 1 and Ref 2 In (From Frame) – the Ref 1 arrow will be present when
Frame Bus 1 has been enabled on the module in slot 1. The Ref 2 arrow
will be present when Frame Bus 2 has been enabled on the module in
slot 3 of the frame.
When the module detects an error, a warning messages, such as signal or
reference not present, will appear between the lines below the status
graphic as illustrated in
. Refer to the
for information on disabling the status reporting.
Note
Many of these warnings are informational only and concern frame rate com-
patiblilty. Pay close attention to the frame rate compatibility explanations and
tables in this manual.
The installation status of the Genlock Module or Fiber Optic submodule
will also be reported here as well as being shown in the graphic.
Information about the module, such as part number, serial number, hard-
ware revision and software and firmware versions, and asset tag number
(assigned on the Slot config web page) are given in a read-only section at
the bottom of the display.