Grass Valley 8995DNC v.1.3.0 - Manual (Page 34)

34 8995UPC/DNC/UDX — Instruction Manual
Configuration
Remote Configuration and Monitoring
8995 module configuration and monitoring can only be performed using a
web browser GUI interface or a networked Newton Control Panel when
the 8900NET Network Interface module is present in the GeckoFlex frame.
Each of these interfaces is described below.
Local/Remote Jumper
The on-board jumper Local/Remote jumper, J1, ( Figure 14 ) must be set for
local and remote (LOC/REM position, pins 2-3) for remote control or set to
(LOC position, pins 1-2) to lock out remote control.
Figure 14. Module Configuration Switches and LEDs
8900NET Module Information
Refer to the 8900NET Network Interface Module Instruction Manual for infor-
mation on the 8900NET Network Interface module and setting up and
operating the GeckoFlex frame network.
Note The 8900NET module in the GeckoFlex frame should be running software
version 4.3.0 or higher for optimum remote and control panel operation and
is required for software updating. Upgrade software and instructions for the
8900NET can be downloaded from the Grass Valley web site. See
System
Requirements on page 11 for 8900NET software updating.
Local/Remote
Jumper, J1