H3C Technologies H3C Intelligent Management Center - Manual (Page 46)

36
• Click the Previous Page icon to page backward in the Protocol List.
• Click the First Page icon to page backward to the front of the Protocol List.
• Select 8, 15, 50, 100, or 200 from the list at the lower right of the Protocol List to configure
how many items per page you want to display.
• For a Protocol List that has more than one page, click a number on the lower right side of the
main pane to go to that page.
• To query NTA for the most current Protocol List, click the Refresh button in the upper left corner
of the Protocol List.
NOTE:
You can sort the Protocol List by the Protocol Name, Protocol Number, Enable, and Pre-defined fields.
Click the column label to sort the list by the selected field. The column label allows you to toggle between
the sort options specific to each field.
Querying the protocol list
1. Select Service > Traffic Analysis and Audit > Settings.
2. In the Settings area of the Traffic Analysis and Audit page, click the Application Management link.
3. In the upper left corner of the Application Management page, click the Protocol tab.
NTA displays all protocols in NTA in the Protocol List in the main pane of the Application
Management page.
4. In the upper right corner of the Protocol List page, enter a partial or complete name of the protocols
to be queried in the query criteria field, and click the Query icon
to filter out the unmatched
protocols.
To filter protocols by using more query criteria, click the Advanced icon to the right of the
query criteria field to expand the query criteria panel above the protocol list. Enter or select one or
more of the following query criteria:
• Protocol Name—Enter a partial or complete name for the protocols for which you want to
search.
• Protocol Number—Enter the number NTA has assigned to the protocol (not the port number
for the protocol).
• Enable—Select Yes to filter the list for all protocols that are enabled for analysis and reporting.
Select No to filter the list for all protocols that are disabled from analysis and reporting. Select
Not limited if you do not want to filter the list by protocols that have been either enabled or
disabled.
• Pre-defined—Select Yes to filter for protocols that are predefined. To filter for protocols that
are user-defined, select No from the list. To include system or predefined as well as
user-defined protocols, select Not limited.
5. Click Query to begin your search.
The results of your search appear on the Protocol List.
6. When you have finished reviewing the results of your query, click Reset to restore the full contents
of the Protocol List.