Query protocols – H3C Technologies H3C Intelligent Management Center User Manual
Page 186
176
application reports for the selected probe traffic analysis task, and set Query Type to Protocol as
described in "
." For more information on protocols in NTA, see "
."
The following information describes the reports available for protocols.
Query protocols
To view reports by protocol, you must configure the filter criteria for application reports. You can change
the default settings for query type, protocol, or time range for the graphs and tables to customize the
reports displayed on the Application tab.
1.
Click the query criteria icon
in the upper right corner of Application Report, and select Custom
from the list that appears. Or, click the Advanced icon
to the right of the query criteria field to
expand the query criteria setting area.
2.
Select Protocol from the Query Type list. The page displays the report for protocols.
3.
Enter or select the other query criteria:
•
Protocol—To select the protocol you want to search for, click the Select button next to the
Protocol field.
The Query Protocols dialog box displays an empty Protocol List.
To select the protocol you want to search for, you must first query the Protocol List as follows:
a.
Enter or select one or more of the following search criteria in the Query Protocols area of the
dialog box:
•
Protocol—Enter a partial or complete name for the protocols you want to search for in the
Protocol field.
•
Pre-defined—To search for protocols that are predefined, select Yes in the Pre-defined
list.
To filter for protocols that are user-defined, select No.
To include system or predefined and user-defined protocols, select Not limited.
b.
To display the full Protocol List, click Query without entering any search criteria.
c.
Click Query to begin your search. The results of your query are displayed in the Protocol List
displayed below the Query Protocols area.
d.
Select the check boxes next to the protocols for which you want to search.
e.
Click OK to add the protocols to the filter.
The protocols you selected are displayed in the Protocol field.
Click the Clear button to the right of the Protocol field to clear all selected protocols.
•
Start Time—Enter the start time of the time range, in the format of YYYY-MM-DD hh:mm. Or,
click the Calendar icon
to the right of the input box to manually specify a start time.
•
End Time—Enter the end time of the time range, in the format of YYYY-MM-DD hh:mm. Or,
click the Calendar icon
to the right of the input box to manually specify an end time.
Additionally, to set the start time and end time for the protocol report, you can click the query
criteria icon
in the upper right corner of the protocol report. On the list that appears, select
Last 1 hour, Last 3 hours, Last 12 hours, Last 24 hours, Last 7 days, Last 30 days, Last 3
months, or Custom. Click the Query icon
in the query criteria area to set the time range
for the traffic report for protocols.