H3C Technologies H3C Intelligent Management Center - Manual (Page 160)

150
• The TopN Applications Communicating with the Source Host displays the TopN applications, the
volume of traffic attributed to the associated application for the selected source host, and the
percentage of the associated application traffic observed for this source host.
Figure 81 Source Report: Traffic Details For Source Host
Destination reports
Destination reports provide rate and percentage distribution of traffic by destination host for all VLANs
configured in a VLAN traffic analysis task or for an individual VLAN in a task. Click the Destination tab
to view traffic reports.
Destination reports contain the following fields:
• Query Destinations—Set the time range for the destination host reports.
• TopN Traffic Report for Destination Host—Displays the distribution of traffic that generated by the
TopN destination hosts for all VLANs in the selected traffic analysis task or for a VLAN in a task.
• TopN Traffic List for Source Host—Provides a list of the TopN destination hosts measured by volume
of traffic on all VLANs in the selected traffic analysis task or for a VLAN in a task.
• Traffic Trend Report for Destination Host—Provides the average rate of traffic for the selected
destination host.
• Traffic Details—For a source host table, provides two lists:
{
TopN Source Hosts Communicating with the Destination Host
The list displays the TopN source host IP addresses, the volume of traffic sent and received
between this destination host and the sources, and the percentage of all traffic observed for this
destination host and the source hosts.
{
TopN Applications Communicating with the Destination Host
The list displays the TopN applications, the volume of traffic attributed to the associated
application for the selected destination host, and the percentage of the associated application
traffic observed for this destination host.
The introduction to destination host reports also applies to individual VLANs in VLAN traffic analysis
tasks.
Query destinations
NTA enables you to change the filter criteria for destination reports. You can change the default settings
for destination host, or time range to customize the charts and lists displayed.
1. In the query criteria area in the upper right corner of the source report, click the query criteria icon
. On the list that appears, select Last 1 hour, Last 3 hours, Last 12 hours, Last 24 hours, Last 7
days, Last 30 days, Last 3 months, or Custom. Click the Query icon in the query criteria area
to set the time range for the source report.