H3C Technologies H3C Intelligent Management Center - Manual (Page 151)

141
Query protocols
To view reports by protocol, you must configure the filter criteria for protocol reports. To customize the
reports displayed, the protocol query option enables you to change the default settings for query type,
protocol, or time range for the graphs and tables.
1. Click the query criteria icon in the upper right corner of Application Report, and select Custom
from the list that appears. Or, click the Advanced icon to the right of the query criteria field to
expand the query criteria setting area.
2. Select Protocol from the Query Type list.
The page refreshes the report for protocols.
3. Enter or select the other query criteria:
• Protocol—To select the protocol you want to search for, click the Select button located to the
right of the Protocol field. The Query Protocols dialog box is displayed and an empty
Protocols List is displayed in the lower portion of the dialog box.
a. Enter or select one or more of the following search criteria in the Query Protocols area of the
dialog box:
• Protocol—Enter a partial or complete name for the protocols you want to search for in the
Protocol field.
• Pre-defined—To search for protocols that are predefined, select Yes from the Pre-defined
list. To filter for protocols that are user-defined, select No from the list. To include system or
predefined as well as user-defined protocols, select Not limited.
b. Click Query to begin your search. The results of your query are displayed in the Protocol List
displayed below the Query Protocols area. To display the full Protocol List, click Query without
entering any search criteria.
c. Select the check boxes next to the protocols you want to add to the application category.
d. Click OK to add the protocols to the filter. The protocols you selected are displayed in the
Protocol field. Click the Clear button located to the right of the Protocol field to clear all selected
protocols.
• Start Time—Enter the start time of the time range, in the format of YYYY-MM-DD hh:mm. Or,
click the Calendar icon to the right of the input box to manually specify a start time.
• End Time—Enter the end time of the time range, in the format of YYYY-MM-DD hh:mm. Or,
click the Calendar icon to the right of the input box to manually specify an end time.
Additionally, to set the start time and end time for the application report, you can click the
query criteria icon
in the upper right corner of the protocol report. On the list that appears,
select Last 1 hour, Last 3 hours, Last 12 hours, Last 24 hours, Last 7 days, Last 30 days, Last
3 months, or Custom. Click the Query icon
in the query criteria area to set the time range
for the traffic for protocols.
4. Click OK.
Protocol list
The Protocol List provides a list of the protocols for all VLANs in the selected traffic analysis task or for a
VLAN in a task for the selected time range. This list includes the protocol name, total volume of traffic for