H3C Technologies H3C Intelligent Management Center - Manual (Page 271)

261
The inbound report includes the TopN Traffic List for Destination Host, which provides a list showing
volume and percentage of traffic sent to each of the TopN destination hosts that configured in the
selected task by any other hosts. The outbound report also includes the TopN Traffic Report for
Destination Host bar/pie chart.
This bar chart displays the average rate of traffic sent to the TopN destination hosts by the hosts
configured in the task. This pie chart displays the distribution of traffic sent to the TopN destination hosts
by the hosts configured in the task.
The outbound report also includes the TopN Traffic List for Destination Host, which provides a list
showing volume and percentage of traffic sent to each of the TopN destination hosts by the hosts that
configured in the selected task. These lists also contain a link to reports for the selected destination host.
The host query icon
next to the Destination IP address is a link for initiating a host query and a link
to the results of the host query. NTA also provides a query option for filtering reports based on criteria you
define.
To view the reports for a host traffic analysis task, click the Destination tab to view traffic reports for the
selected host traffic analysis task.
Query destinations
NTA enables you to change the filter criteria for destination reports. You can change the default settings
for destination host, or time range to customize the charts and lists displayed under the Destination tab.
1. In the query criteria area in the upper right corner of the destination report, click the query criteria
icon
. On the list that appears, select Last 1 hour, Last 3 hours, Last 12 hours, Last 24 hours,
Last 7 days, Last 30 days, Last 3 months, or Custom. Click the Query icon in the query criteria
area to set the time range for the source report.
2. To customize the time range for the source report, select Custom from the list that appears in the
query criteria area, or click the Advanced icon
to the right of the query criteria field to expand
the query criteria setting area.
3. Enter or select one or more of the following query criteria:
• Destination Host—In the Destination Host field, enter the IP address or address range. To
enter the IP address for a single host, enter the IP address using dotted decimal notation.
An example of a valid IP address entry:
10.153.89.10
An example of a valid network/subnet mask in dotted decimal notation:
10.153.89.0/255.255.255.0
A valid network/subnet mask entry using CIDR notation:
10.153.89.0/24
An example of a valid IPv6 address entry:
a001:410:0:1::1
A valid IPv6 address and subnet mask using CIDR notation:
a001:410:0:1::1/64
• Start Time—Enter the start time of the time range, in the format of YYYY-MM-DD hh:mm. Or,
click the Calendar icon to the right of the input box to manually specify a start time.
• End Time—Enter the end time of the time range, in the format of YYYY-MM-DD hh:mm. Or,
click the Calendar icon to the right of the input box to manually specify an end time.