Configuring the rmon alarm function – H3C Technologies H3C SecBlade LB Cards User Manual
Page 79
70
•
You can configure multiple history control entries for one interface, but must make sure their entry
numbers and sampling intervals are different.
•
The device supports up to 100 history control entries.
•
You can successfully create a history control entry, even if the specified bucket size exceeds the
history table size supported by the device. However, the effective bucket size will be the actual value
supported by the device.
To configure the RMON history statistics function:
Step Command
1.
Enter system view.
system-view
2.
Enter Ethernet interface view.
interface interface-type interface-number
3.
Create an entry in the RMON history
control table.
rmon history entry-number buckets number interval
sampling-interval [ owner text ]
Configuring the RMON alarm function
Follow these guidelines when you configure the RMON alarm function:
•
To send traps to the NMS when an alarm is triggered, configure the SNMP agent as described in
"Configuring SNMP" before configuring the RMON alarm function.
•
If the alarm variable is a MIB variable defined in the history group or the Ethernet statistics group,
make sure the RMON Ethernet statistics function or the RMON history statistics function is
configured on the monitored Ethernet interface. Otherwise, even if you can create the alarm entry,
no alarm event can be triggered.
•
You cannot create a new event, alarm, or private alarm entry that has the same set of parameters
as an existing entry. For parameters to be compared for duplication, see
•
After the maximum number of entries is reached, no new entry can be created. For the table entry
limits, see
To configure the RMON alarm function:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create an event entry in
the event table.
rmon event entry-number [ description string ] { log |
log-trap log-trapcommunity | none | trap
trap-community } [ owner text ]
N/A