Snmp logging configuration example, Network requirements, Configuration procedure – H3C Technologies H3C SecBlade LB Cards User Manual
Page 73
64
1.1.1.1/3374 V3 Trap = linkdown
SNMP Version = V3
Community = managev3user
Command = Trap
1.1.1.1/3374 V3 Trap = linkup
SNMP Version = V3
Community = managev3user
Command = Trap
SNMP logging configuration example
Network requirements
Configure the SNMP agent (1.1.1.1/24) in
to log the SNMP operations performed by the NMS.
Figure 27 Network diagram
Configuration procedure
This example assumes that you have configured all required SNMP settings for the NMS and the agent
(see "
SNMPv1/SNMPv2c configuration example
").
# Enable displaying log messages on the configuration terminal. (This function is enabled by default.
Skip this step if you are using the default.)
# Enable the information center to output system information with severity level equal to or higher than
informational to the console port.
[Agent] info-center source snmp channel console log level informational
# Enable logging GET and SET operations.
[Agent] snmp-agent log all
# Verify the configuration:
Use the NMS to get a MIB variable from the agent. The following is a sample log message displayed on
the configuration terminal:
%Nov 23 16:10:09:482 2011 Agent SNMP/6/SNMP_GET:
-seqNO=27-srcIP=1.1.1.2-op=GET-node=sysUpTime(1.3.6.1.2.1.1.3.0)-value=-node=ifHCOutO
ctets(1.3.6.1.2.1.31.1.1.1.10.1)-value=; The agent received a message.
Use the NMS to set a MIB variable on the agent. The following is a sample log message displayed on
the configuration terminal: