Outputting system information to the snmp module – H3C Technologies H3C SecBlade LB Cards User Manual

Page 28

Step Command

Remarks

Configure an output rule for

the log buffer.

info-center source { module-name |
default } channel { channel-number
| channel-name } [ debug { level

severity | state state } * | log { level

severity | state state } * | trap
{ level severity | state state } * ] *

Optional.
See "

Default output rules of system

information

Configure timestamp format.

info-center timestamp { debugging
| log | trap } { boot | date | none }

Optional.
The timestamp format for log, trap
and debug information is date by

default.

Outputting system information to the SNMP module

The SNMP module only receives trap information, and discards log and debug information.
To monitor the device running status, trap information is usually sent to the SNMP network management

system (NMS). For this purpose, you must configure output of traps to the SNMP module, and set the trap

sending parameters for the SNMP module. For more information about SNMP, see "Configuring SNMP."
To output system information to the SNMP module:

Step Command

Remarks

Enter system view.

system-view

N/A

Enable the information center. info-center enable

Optional.
Enabled by default.

Name the channel with a

specified channel number.

info-center channel
channel-number name
channel-name

Optional.
See

Table 2

for default channel

names.

Configure an output channel
for the SNMP module.

info-center snmp channel

{ channel-number |
channel-name }

Optional.
By default, system information is
output to the SNMP module

through channel 5 (known as

snmpagent).