H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 79)

70
Configuration procedure
# Enable the information center.
system-view
[Sysname] info-center enable
# Use channel console to output log information to the console (optional, console by default).
[Sysname] info-center console channel console
# Disable the output of log, trap, and debugging information of all modules on channel console.
[Sysname] info-center source default channel console debug state off log state off trap
state off
To avoid output of unnecessary information, disable the output of log, trap, and debugging information
of all modules on the specified channel (console in this example), and then configure the output rule as
needed.
# Configure an output rule to enable the AP to send ARP and IP log information that has a severity level
of at least informational to the console. (Note that the source modules allowed to output information
depend on the AP model.)
[Sysname] info-center source arp channel console log level informational state on
[Sysname] info-center source ip channel console log level informational state on
[Sysname] quit
# Enable the display of log information on a terminal. (Optional, this function is enabled by default.)
terminal monitor
Info: Current terminal monitor is on.
terminal logging
Info: Current terminal logging is on.
Now, if the ARP and IP modules generate log information, the information center automatically sends the
log information to the console.