Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 36
27
[Switch A-vlan3] quit
[Switch A] interface vlan-interface 3
[Switch A-Vlan-interface3] igmp enable
[Switch A-Vlan-interface3] igmp static-group 224.0.1.1
[Switch A-Vlan-interface3] quit
[Switch A] interface ethernet 1/0/1
[Switch A-Ethernet1/0/1] igmp-snooping static-group 224.0.1.1 vlan 3
4.
Configure AP 1:
[AP1] interface vlan-interface 3
# Configure AP 1 to operate in multicast client mode and receive multicast messages on VLAN-interface
3.
[AP1-Vlan-interface3] ntp-service multicast-client
# Display the NTP status of AP 1 after clock synchronization.
[AP1-Vlan-interface3] display ntp-service status
Clock status: synchronized
Clock stratum: 3
Reference clock ID: 3.0.1.31
Nominal frequency: 100.0000 Hz
Actual frequency: 100.0000 Hz
Clock precision: 2^16
Clock offset: 0.0000 ms
Root delay: 40.00 ms
Root dispersion: 10.83 ms
Peer dispersion: 34.30 ms
Reference time: 16:02:49.713 UTC Sep 19 2005 (C6D95F6F.B6872B02)
The output shows that AP 1 has been synchronized to Switch B, and the clock stratum level of AP 2 is 3,
while that of Switch B is 2.
# Display NTP session information for AP 1, which shows that an association has been set up between
AP 1 and Switch B.
[AP1-Vlan-interface3] display ntp-service sessions
source reference
stra reach poll now offset delay disper
**************************************************************************
[1234] 3.0.1.31 127.127.1.0 2 255 64 26 -16.0 40.0 16.6
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations : 1
Configuring NTP client/server mode with authentication
Network requirements
As shown in
, perform the following configurations to synchronize the time between the AP and
the device and ensure network security.
•
The local clock of the device is to be configured as a reference source, with the stratum level 2.
•
The AP operates in client mode and the device is to be used as the NTP server of the AP.
•
NTP authentication is to be enabled on both the device and the AP.