beautypg.com

Sending inform messages, Connection – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 60

background image

51

If the interface that connects the CPE to the ACS is the only Layer 3 interface that has an IP address on

the device, you do not need to specify the CWMP connection interface. If multiple Layer 3 interfaces are
configured, specify the CWMP connection interface to make sure that the IP address of the interface

connects to the ACS is sent to the ACS for setting up CWMP connection.
To configure a CWMP connection interface:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter CWMP view.

cwmp

N/A

3.

Set the interface that connects
the CPE to the ACS.

cwmp cpe connect interface
interface-type interface-number

The default CWMP connection
interface is VLAN-interface 1.

Sending Inform messages

Inform messages need to be sent during the connection establishment between a CPE and an ACS. You

can configure the Inform message sending parameter to trigger the CPE to initiate a connection to the

ACS.
To configure the CPE to send Inform messages periodically:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter CWMP view.

cwmp

N/A

3.

Enable the periodical sending
of Inform messages.

cwmp cpe inform interval enable

By default, this function is disabled.

4.

Configure the interval

between sending the Inform
messages.

cwmp cpe inform interval seconds

Optional.
By default, the CPE sends an Inform
message every 600 seconds.

To configure the CPE to send an Inform message at a specific time:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Enter CWMP view.

cwmp

N/A

3.

Configure the CPE to send an
Inform message at a specific

time.

cwmp cpe inform time time

By default, no time is set. The CPE
is not configured to send an Inform
message at a specific time.

Configuring the maximum number of attempts made to retry a
connection

If a CPE fails to establish a connection to an ACS, or the connection is interrupted during the session (the

CPE does not receive a message indicating the normal close of the session), the CPE can automatically
reinitiate a connection to the ACS.

This manual is related to the following products: