beautypg.com

System debugging, Debugging information control switches – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 14

background image

5

Using a tracert command to identify failed or all nodes in a
path

To execute tracert commands to identify failed or all nodes in a path:

Step Command

Remarks

1.

Enter system view.

system-view

N/A

2.

Display the routes from source
to destination.

For IPv4 networks:
tracert [ -a source-ip | -f first-ttl

| -m max-ttl | -p port | -q

packet-number | -w timeout ] *
host

For IPv6 networks:

tracert ipv6 [ -f first-ttl | -m
max-ttl | -p port | -q

packet-number } | -w timeout ]

* host

Use either approach.
Available in any view.

System debugging

The device supports debugging for the majority of protocols and features, and provides debugging

information to help users diagnose errors.

Debugging information control switches

The following switches control the display of debugging information:

Protocol debugging switch, which controls protocol-specific debugging information.

Screen output switch, which controls whether to display the debugging information on a certain
screen.

Output of debugging information depends on the configurations of the information center and the

debugging commands of each protocol and functional module. Displaying the debugging information
on a terminal (including console or VTY) is a common way to output debugging information. You can

also output debugging information to other destinations. For more information, see "Configuring the

information center."
As shown in

Figure 3

, assume that the device can provide debugging for the three modules 1, 2, and 3.

The debugging information can be output on a terminal only when both the protocol debugging switch

and the screen output switch are turned on.

This manual is related to the following products: